Your Complete Guide to the Pro Laser Renewal Wand Ritual

Great skin technology should feel intuitive, not intimidating. The Pro Laser Renewal Wand brings pro-level, multi-modal light therapy into your hands, with modes that adapt to whatever your skin needs that day. Pair it with our new light-activated skincare system, and you’ve got a ritual built for real, cumulative results. Here’s how it all works.

Key Takeaways

• The Pro Laser Renewal Wand combines an 808nm cold laser with red, near-infrared, and blue LED light, plus a swappable cryo-sculpting head.

• Prep every session with a spritz of Hydrating Botanical Facial Mist and one pump of Light-Activated Peptide Serum.

• Hold the wand over each area for 1 to 3 minutes; it beeps every minute to cue you to move.

• Tone + Tighten targets firmness and fine lines, Clear + Calm spot-treats breakouts, and Cryo Sculpting depuffs.

• Results are cumulative: weeks of consistent sessions matter more than any single one.

What Is the Pro Laser Renewal Wand?

The Pro Laser Renewal Wand is a handheld cold laser device that combines 808nm laser precision with red, near-infrared, and blue LED light therapy, plus an interchangeable cryo-sculpting head for cooling and depuffing. Three technologies, one tool, built to treat exactly what your skin needs in the moment. It’s the precision, handheld option in our lineup of red light therapy devices.

The wand comes with two swappable heads:

• Light therapy head — toggles between two modes, Tone + Tighten and Clear + Calm

• Cryo-sculpting head — instantly cools and depuffs while supporting lymphatic drainage

Switching between them takes seconds. Then, just select your mode, glide the wand over your skin the way you would a gua sha to warm things up, then hold it in place over each area for 1 to 3 minutes. A gentle beep sounds to cue you when it’s time to move to the next spot, so you’re never guessing.

What to Put on Your Face Before Red Light Therapy

With the Pro Laser Renewal Wand, prep in two steps: a spritz of the Hydrating Botanical Facial Mist, then one pump of the Light-Activated Peptide Serum. Most general red light advice says to treat bare skin and save serums for after. This system is the exception, because both formulas are designed to be on your skin while the light is on.

Red light gives your skin the stimulus. What your skin does with that stimulus depends on what it has to work with.

Red light therapy activates cellular energy and repair pathways, but the quality of that response depends on whether skin has the nutrients, hydration, and antioxidant support it needs to make the most of that energy. That’s where our light-activated skincare system comes in: the Light-Activated Peptide Serum and Hydrating Botanical Facial Mist, formulated with light-responsive ingredients designed to help your skin better receive and respond to light therapy. For more on how ingredients and light work together, see our guide to the best serums to use with red light therapy.

Light-Activated Peptide Serum is built around pure GHK-Cu copper peptide, plus a multi-peptide complex, niacinamide, and multi-weight hyaluronic acid. Together, they support the skin’s natural repair response, help improve firmness and elasticity, and deliver lasting hydration.

Hydrating Botanical Facial Mist is formulated with light-responsive green tea, along with calendula, gotu kola, and ectoin. It hydrates, calms, and helps prep skin to receive light, and it’s just as good as a refresher any time of day.

Apply both before your treatment, and mist again anytime during your session to keep skin comfortable and hydrated.

How to Use a Red Light Therapy Wand, Mode by Mode

Prep your skin, choose the mode that matches today’s concern, glide the wand to warm your skin, then hold it over each area for 1 to 3 minutes. The wand has three modes across two swappable heads:

Tone + Tighten Mode: For Firmness and Fine Lines

This is your go-to for firming and rejuvenation. Tone + Tighten combines 630nm red light, 830nm near-infrared, and the 808nm cold laser to help visibly firm and smooth skin, support collagen production, and soften the look of fine lines and wrinkles.

How to use it:

1. Spritz the Hydrating Botanical Facial Mist over clean skin, then apply one pump of the Light-Activated Peptide Serum.

2. Select Tone + Tighten mode.

3. Glide the wand over your skin to warm it up, the same way you’d move a gua sha.

4. Hold the wand over each area of concern for 1 to 3 minutes. The wand will beep every minute to cue you to move on.

5. Target areas like the forehead, crow’s feet, smile lines, jawline, neck, and décolleté.

Tone + Tighten isn’t just a face treatment. It works anywhere you want extra support, like your neck, knees, or any spot showing fine lines or laxity.

Clear + Calm Mode: For Breakouts and Redness

When breakouts or redness are the priority, switch to Clear + Calm. This mode uses 415nm blue light to help target acne-causing bacteria, support visibly clearer skin, and calm the look of redness.

How to use it:

1. Prep the same way: mist, then one pump of serum.

2. Select Clear + Calm mode.

3. Hold the wand over breakout-prone areas, like the T-zone, chin, or jawline, for 1 to 3 minutes each.

4. This mode is meant for spot treatment. Use it only where you need it rather than across your whole face.

A note on blue light: it may not be appropriate for darker skin tones. If you’re unsure whether it’s right for you, check with your dermatologist first.

Clear + Calm can be used anywhere on the body that experiences breakouts, not just the face.

Cryo Sculpting Mode: For Depuffing and a Quick Reset

When your skin needs an instant reset, swap in the cryo-sculpting head. With two cooling levels, this mode helps depuff, support lymphatic movement, calm stressed or overheated skin, and boost circulation for a refreshed look.

How to use it:

1. Mist your skin first to help the head glide smoothly.

2. Use upward, outward strokes along the jawline, cheekbones, and under-eyes to depuff and sculpt.

3. Finish with another spritz of mist for an extra cooling boost.

Pro tip: reach for cryo whenever your skin needs a refresh, whether that’s post-workout, a midday pick-me-up, or the last step in your routine. No need to remove makeup first.

Already Have the Red Light Face Mask? Here’s How to Use It With the Wand

Yes, you can use both. Use the Red Light Face Mask for full-face, hands-free sessions and the Wand to spot-treat a specific line, breakout, or puffiness. Both use the same serum and mist prep.

Think of the Wand and the mask as two different tools for two different jobs. The mask is your full-coverage, hands-free option, great for multitasking while you get ready or wind down. The Wand is your precision tool, built for targeting exactly what’s bothering you in the moment, whether that’s a stubborn line, a breakout, or puffiness under your eyes.

You don’t have to choose. Use the mask for your broader, consistent red light sessions, and bring in the Wand when you want to spot-treat, whether that’s on your face or anywhere else on your body that needs a little extra attention. Both pair with the same Peptide Serum and Facial Mist, so your prep step stays exactly the same no matter which tool you reach for.

Consistency Is Everything: Building Your Red Light Therapy Routine

Prep with mist and serum every session, use each mode where your skin needs it, and keep your sessions regular. Results build over weeks, not after one session. For general timing guidance, see how often to use red light therapy.

Like any skin ritual, the Wand rewards regular use. One session feels great. Weeks of consistent sessions are what actually change your skin.

Build it into your routine, stay consistent, and let the ritual do its work over time.

Red Light Therapy Wand FAQs

How long do you hold a red light therapy wand on each area?

Hold the Pro Laser Renewal Wand over each area for 1 to 3 minutes. Start by gliding it across your skin, the way you would a gua sha, to warm things up. The wand beeps every minute, so you always know when it is time to move on to the next spot.

Should you apply serum before or after using a red light therapy wand?

With this system, apply it before. Spritz the Hydrating Botanical Facial Mist over clean skin, then apply one pump of the Light-Activated Peptide Serum. Both are formulated with light-responsive ingredients designed to help skin receive and respond to light. Mist again anytime during your session to keep skin hydrated.

Can you use a red light therapy wand on your body?

Yes. Tone + Tighten works anywhere you want extra firming support, such as your neck, décolleté, or knees. Clear + Calm can spot-treat breakouts on the body, not just the face. The cryo-sculpting head can be used anywhere your skin needs a cooling refresh, including post-workout.

Is blue light therapy safe for darker skin tones?

Blue light may not be appropriate for darker skin tones. If you are unsure whether Clear + Calm mode is right for you, check with your dermatologist before using it. When you do use it, keep it to spot treatment on breakout-prone areas rather than across your whole face.

Do red light therapy wands actually work?

Results are cumulative. Red and near-infrared light help support collagen production and soften the look of fine lines, but one session will not change your skin on its own. Weeks of consistent sessions, paired with the right prep, are what make the visible difference over time.

Do you need to remove makeup before using the cryo-sculpting head?

No. Unlike the light therapy modes, which start on clean skin, cryo can be used over makeup. Reach for it post-workout, as a midday pick-me-up, or as the last step in your routine, then finish with a spritz of mist for an extra cooling boost.